RP-30 (NBR)
- Rod / Piston Seal NBR/Fabric Type: RP-30
Dimensions: 10 x 17 x 6.3 x 6Part number: 84001In StockMore Details - Rod / Piston Seal NBR/Fabric Type: RP-30
Dimensions: 10 x 18 x 6 x 5.5Part number: 71868Delivery time: ± 6 weeksMore Details - Rod / Piston Seal NBR/Fabric Type: RP-30
Dimensions: 10 x 19 x 6.3 x 6Part number: 314596In StockMore Details - Rod / Piston Seal NBR/Fabric Type: RP-30
Dimensions: 100 x 115 x 12 x 11.7Part number: 69435In StockMore Details - Rod / Piston Seal NBR/Fabric Type: RP-30
Dimensions: 100 x 120 x 14 x 13.7Part number: 32251In StockMore Details - Rod / Piston Seal NBR/Fabric Type: RP-30
Dimensions: 110 x 125 x 12 x 11.7Part number: 72787In StockMore Details
RP-30
Description
The RP-30 is a single acting piston seal which consists of reinforced cotton fabric and nitrile rubber vulcanized together forming an integral sealing element.
Product advantages
- functions even with poor surfaces
- reinforced cotton fabric base prevents the seal from extrusion
- both rod and piston application
- good sealing at low pressures
Applications
Low to medium duty hydraulic cylinders, mobile hydraulics and presses.
Operating conditions
Media | Mineral oils (DIN 51524) | HFA and HFB | HFC |
Temperature (min.) °C | -30 | +5 | -30 |
Temperature (max.) °C | +105 | +60 | +60 |
Pressure Bar | ≤250 | ≤250 | ≤250 |
Speed m/sec | ≤0,5 | ≤0,5 | ≤0,5 |
Note: The above data are maximum values and cannot be used at the same time.
Surface roughness
Surface roughness | Ra | Rmax |
Sliding Surface ØD-Ød | ≤0.4 μm | ≤3.2 μm |
Groove Base ØDb-Ødp | ≤1.8 μm | ≤6.3 μm |
Groove Flanks B | ≤3.2 μm | ≤16 μm |
Note: It is recommended to have 50% to 90% of the working surface value.
d (h9)/dp (f8)
Db (H11)/D(H9)
B (-0/+0.2)
Installation
The RP-30 is to be assembled into open grooves. It is very important that the assembly tools must be of soft material and have no sharp edges. Before installation the sealing element must be oiled with system oil.
permissible sealing gap
pressure (bar) | 150 | 250 |
Smax (mm.) | 0,20 | 0,10 |
Note: The largest sealing gap value occurring on the non-pressurized side of the seal does have a vital importance for the function of the seal and in this respect it is quite important to use the S value lower than the above indicated numbers.